New To Forum

New To Forum

Postby Blackmax on Fri Nov 22, 2019 11:38 pm

Hi All,
I have a Verminator MK1 to service, I'd be grateful if someone could advise me how to get the rear hex screw out if the block which sits under the pellet probe.

I'm also after the size of the breach seal O ring on a .22 model and the barrel O ring sizes.

Posts: 4
Joined: Sat Nov 16, 2019 12:38 pm

Re: New To Forum

Postby stanimal on Thu Dec 12, 2019 8:13 pm

Hi mate, the pellet probe looks like one long brass rod but it should unscrew into two pieces,pull it out as far as you can and try to unscrew it,be careful though as it might be in tight and take some effort, and if you use pliers try to grip it with some hard rubber or something as brass it pretty soft and easy to mark.

Posts: 4
Joined: Wed Dec 31, 2014 1:16 am

Return to FX General

Who is online

Users browsing this forum: No registered users and 5 guests