

cyclone sniper wrote:has to be something simple causing the low power ??????
jackdaw wrote:my gun and it must be all verminators and unregulated pcps set at 12 ft lbs they only reach there full power when the pressure in the gun is at about 140 bar . that is the top of a power curve . when the presure is above 140 bar say 190 bar the hammer dosent have enough energy to open the valve fully so the pellet dosent get enough air behind it for it to reach 12 ft lbs .when the air is below 140 bar say 90 bar there is not enough air with enough pressure behind the pellet for it to reach 12 ft lbs . . So shooting the gun between 155 bar to 120 bar about .is the best for me my gun shoots at 11.5 it looses a bit of power through the breach seal so my gun is shooting at 11.2 right now i cant be bothered to change the breach seal on my gun it does wear out a bit quick .
Users browsing this forum: No registered users and 4 guests