Page 1 of 1

the Value pin guide make me disappointed

PostPosted: Sun Dec 20, 2009 11:07 pm
by sinking
I got the brand new revolution in U.S.,, when i get that i try to compress the air,, the problems are comes out.

First, the value did'nt close , so the air are leaking from the barrel, i can't pump in any air..

The problem two, the air tank also has the air leaking.

And then i dispode the gun and find out the problems, the value problem is the value pin guide hole is not at the center of the recoil pipe,

so i use the machine to fix it,, and i fix up the revolution , but the air tank air leaking still reminds, i think i need go to buy another air tank.

but i right now , i can use my Gladiator air tank to replace temporarily...i also got the gladiator too,, this is very nice i modify power myself...

i 'm planning to modify the Revolution power too... my Gladiator 5.5mm caliber achieve 1300fps about 70-80joules and my 5.5mm caliber monsoon the power almost achieve 1250fps too.. i will try to make more report and picture for you guys....

Re: the Value pin guide make me disappointed

PostPosted: Wed Dec 23, 2009 6:47 pm
by bitmonx
hey

we are verry interested in a guide " how to get such massive power from a fx". :o

Re: the Value pin guide make me disappointed

PostPosted: Sun Jan 10, 2010 6:58 pm
by sinking
The revoltuon valve pin fix with machine

Re: the Value pin guide make me disappointed

PostPosted: Sun Jan 10, 2010 7:06 pm
by sinking
This is the valve pin guide hole inside the recoil pipe after drill adjustment, i make this bigger

Re: the Value pin guide make me disappointed

PostPosted: Sun Jan 10, 2010 8:36 pm
by sinking
i also modify the power of the revolution,, i drill the bigger air flow hole at 5 mm..

Re: the Value pin guide make me disappointed

PostPosted: Sun Jan 10, 2010 8:40 pm
by sinking
The air flow lower body,, the air flow board,, the upper body and the barrel air flow also drill bigger to 5mm..

Re: the Value pin guide make me disappointed

PostPosted: Mon Jan 11, 2010 7:02 am
by sinking
This is the lower body,Air flow board , and the upper body! Also need to drill the bigger to 5mm..

this is the first step for power upgrade!

Re: the Value pin guide make me disappointed

PostPosted: Mon Jan 11, 2010 5:54 pm
by diank56
On the third photography I see two holes.Why?One is for fixing and the other one:what is it for?

Re: the Value pin guide make me disappointed

PostPosted: Wed Jan 13, 2010 6:11 pm
by sinking
the hole the third picture need the fixing stock hole is for the hammer recoil save, the FX 's enginner design this hole is for blowback protection for hammer,, the extra air will come out of the hole , when the hammer blow back to the end.. but i also screwed it, use the 4mm screw can be fit, then the revolution blow back recoil will be hard , even the air is lower than 130bar, revolution also can blow back and shooting, so,, the revolution full charge air with 500cc air tank can be shoot over 70shots... can you get it? Please don;t mind my english not very well....thank you for your reading and share..