Page 1 of 1

Semi-auto not working properly

PostPosted: Fri Sep 10, 2010 9:17 pm
by Cupillac
Hi all!

Not having great luck lately!
My new Revolution stops firing in semi-auto as soon as the gauge hits around 150 BAR

any thoughts/suggestions?

Re: Semi-auto not working properly

PostPosted: Sat Sep 11, 2010 8:12 am
by PolarWolf
Check the easy stuff first, i.e. whether the gas tube is free of lead dust. The harder stuff is recalibrating the gas cylinder with a set screw. The hardest bit is to take the rifle apart for maintenance which is said to be tricky (but isn't, really)

Re: Semi-auto not working properly

PostPosted: Sat Sep 11, 2010 11:11 pm
by Cupillac
Sorry 120 Bar!
Apparently this is normal for the revolutions?

Re: Semi-auto not working properly

PostPosted: Tue Sep 14, 2010 8:37 am
by PolarWolf
I used to shoot my Revo down to about 110-100 bar. That takes about 5 magazines and the last magazine didn't always repeat well. I'd say 120 bar minimum for proper operation sounds about right.

Re: Semi-auto not working properly

PostPosted: Tue Jun 25, 2013 3:43 am
by GKU
Careful a lot of new owners shoot it down to low and may causes the breech seal to make a hard good bye down the barrel. Not knowing this they wonder why the gun stop cycling.

Re: Semi-auto not working properly

PostPosted: Fri Jan 13, 2017 6:36 pm
by lahoop
Please how can show me how to clean the cocking mechanism of fx revolution in video or photos mine stops working and no maintenance nearby